top of page

Spindle Control

There are multiple ways to control a Spindle from the breakout board.

  • Relay driver for on/off control via external relay - 5 and 12V relays are supported.

  • 5V TTL/SSR output on/off control via an external relay board or solid state relay.

  • Spindle Enable for on/off control via an external spindle controller.

  • Spindle Speed control via an external spindle controller.

  • Spindle Speed control via 0-10V control interface.

​

The 0-10V output is adjustable to fine tune the spindle speed.

​

VFDs (Variable Frequency Drive) are supported .

bottom of page